![]() ![]() The default value is two sessions and the maximum value is four sessions. The Firebox sends a log message when it denies a media session above this number. To identify outgoing SIP traffic as a client you specify, type a new user agent string in the Rewrite user agent as text box. To remove the false user agent, clear the text box. When no data is sent for a specified amount of time on a VoIP audio, video, or data channel, your Firebox closes that network connection. To specify a different time interval, type or select the time in seconds in the Idle media channels text box. Specify the elapsed time interval before the SIP-ALG rewrites the SIP registration value that VoIP phones and PBX systems use to update their registration. The default value is 180 seconds (three minutes) and the maximum value is 600 seconds (ten minutes). To specify a different time interval, type or select the time in seconds in the Registration expires after text box. To send a log message for each connection request managed by the SIP-ALG, select this check box. Override the diagnostic log level for proxy policies that use this proxy action To create accurate reports on SIP traffic, you must select this check box. Then, from the Diagnostic log level for this proxy action drop-down list, select a log level: To specify the diagnostic log level for all proxy polices that use this proxy action, select this check box. The log level you select overrides the diagnostic log level that is configured for all log messages of this proxy policy type.įor more information about the diagnostic log level, see Set the Diagnostic Log Level. WatchGuard and the WatchGuard logo are registered trademarks or trademarks of WatchGuard Technologies in the United States and other countries. Various other trademarks are held by their respective owners.Disable SIP without using recovery mode at all? I have found other threads (such as here and here) about this and the consensus appears to be "no", but I thought I would reiterate the question here to be thorough. Firewall Checker only tests UDP Ports.System Integrity Protection cannot be disabled from a normal mode boot (from ones's Desktop). You need to reconfigure the firewall and test again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |